Screen Protector Installation
Touch screen protectors are available as optional equipment (contact your sales representative to order). The following procedure describes typical installation procedures.
Items recommended for installation:
|
●
|
Microfiber type cloth (lint-free) |
|
●
|
Flexible straight edged tool (e.g. small squeegee, plastic card) |
To install a screen protector:
Cleanliness is the most important factor during the installation of the screen protector. The following tips are provided to assist in the installation:
|
●
|
Clean your hands thoroughly. |
|
●
|
Clean the touch screen thoroughly using a microfiber type cloth, removing all dirt, dust, grease, fingerprints etc. |
|
●
|
Work in a well lit area. |
Minimize dust; work in an area with minimal air movement, turn off fans or air conditioning etc.
|
1.
|
Thoroughly clean and dry the touch screen. |
|
2.
|
Remove the rear mask from the screen protector. |
|
3.
|
Carefully align the edge of the protector with the edge of the screen, and slowly allow the screen protector to lie flat on the screen. |
|
4.
|
Once the protector is in place, use a microfiber cloth to work out any air bubbles. |
To remove air bubbles, slowly work from the inside towards the edges. If large air bubbles are trapped, it may be easier to carefully peel back the protector and re-apply.
If air bubbles are persistent, it is an indication that the screen and/or protector are not clean.
If visible dust is trapped under the protector, peel back the protector and use the adhesive side of a small piece of cellophane tape to remove the dust.
See Care and Cleaning for additional information on cleaning the diagnostic tool.
